Qi-4200
Perfect sound quality and long lifespan
Robust steel 19″ / 1U housing
Suitable for either mobile and installation speakers
Bridge and stereo modus
SMPS, Class D amplification & Soft Start technology
The DAP Qi-4200 is a 4x 200 watt amplifier suitable for the DAP-Xi speaker series. Each channel has its own gain control and protect, limit and signal indicator LEDs. This amplifier is not only suitable for DAP Xi speakers but can also be applied for mobile use due to its rugged steel housing.
The Qi-4200 has 4 routable XLR inputs and speakON outputs. They can be set in either bridge and stereo mode. Equipped with SMPS and Class D amplification, it is a lightweight and energy efficient solution delivering a high quality sound signal.
This device is save to use thanks to its advanced protection circuit. It is protected from overload, overheat and clipping due to various built-in protection mechanisms, such as a softstart and clip limiter. Furthermore, the Qi-series is made with high-quality low-deviation components to ensure a long lifespan and a perfect sound quality.
Output per Channel into 8 ohms at 1 kHz: 120 W
Output per Channel into 4 ohms at 1 kHz: 200 W
Bridge Output into 8 ohms at 1 kHz: 400 W
Output Channels: 4
Output Mode: 4-channel / Bridge / Stereo
Output Connector: Speaker Connector 4 pole
Mono Input Connector: 3-pin XLR
THD Level: < 0.5 %
Signal-to-noise Ratio: > 90 dB
Slew Rate: 15 V/μs
Amp Technology: Class D
Damping Factor: 200 :1
Frequency Response Minimum: 10 Hz
Frequency Response Maximum: 20000 Hz
Power Supply: 100-240 VAC 50-60 Hz
Power Consumption: 725 W
Height (mm): 44 mm
Width (mm): 483 mm
Length (mm): 390 mm
Rack Units: 1 U
Weight: 6.4 kg
Electronic Protection: Clip limiter (fixed) / DC voltage / RF / Short circuit / Softstart / Thermal
